User's Manual

MOD164 TRANSCEIVER

OEM Responsibilities to comply with FCC and Industry Canada

Regulations

The MOD164 Transceiver has been certified for integration into

products only by the OEM integrators under the following conditions:

This device is granted for use in Mobile only configurations per Part

2.1091(b) in which the antennas used must be installed to provide a

separation distance of at least 20cm from all person and not be co-

located with any other transmitters except in accordance with FCC and

Industry Canada multi-transmitter product procedures.

As long as the two conditions above are met, further transmitter

testing will not be required. However the OEM integrator is still

responsible for testing their end product for any additional compliance

requirements required with this module installed.

If the above conditions are not met, then the FCC and Industry

Canada authorizations are no longer valid and the FCC ID and IC

Certification Number cannot be used on the final product. In these

cases the OEM integrator is responsible for re-evaluating the end

product and obtaining a separate FCC and Industry Canada

authorization.

Recertification is also needed for all other operating configurations,

including portable configurations with respect to part 2.1093 and

different antenna configurations.