User's Manual

MOD153 TRANSCEIVER
3
The receivers are matched to
the transmitters to use the same
channel as the transmitter’s
signals.
INSTALLATION
1) Solder the MOD153
transceiver directly to the
host’s compatible connector.
2) Print and attach the label
as shown below:
3) Connect the appropriate
antenna.
Application Requirements:
A) Power the MOD153
Transceiver with 3.3VDC
nominal voltage, with
peak current draw of
150mA.
B)Do not remove the shield
on the MOD153.
C)The antenna should be
mounted at least 20cm
from all persons, and
must not transmit
simultaneously with any
other antenna or
transmitter, except in
accordance with FCC
multi transmitter product
procedures.
D)The MOD153 is to be
installed only in mobile
applications. Do not
operate the MOD153
without an antenna.
E) Documentations: In the
host’s User Manual
include the following:
a. That there are no user
serviceable parts in
the radio modules.
They should not
remove or install radio
modules.
b. The “Instructions To
The User” section.