Installation and Operation Manual

MCT245 RECEIVER
5
Application Requirements:
A) Power the MCT245 Receiver
with 9-30VDC nominal
voltage, with peak
current draw of 150mA.
B)Assemble the MCT245, into
a KAR-TECH Receiver
enclosure.
C) The MCT245 is to be
installed only in mobile
applications. See Part
2.1091 for definitions of
mobile and fixed
applications.
D) Do not operate the MCT245
without an antenna.
E) Documentations: In the
host’s User Manual
include the following:
a. That there are no user
serviceable parts in
the radio product.
They should not
remove or install radio
modules.
b. The “Instructions To
The User” section.
c. The “Industry Canada
Statement”.
d. Include in the manual,
“This device is granted
for use in Mobile only
configurations in
which the antennas
used for this
transmitter must be
installed to provide a
separation distance of
at least 20cm from all
person and not be co-
located with any other
transmitters except in
accordance with FCC
and Industry Canada
multi-transmitter
product procedures.”
BEFORE APPLYING
POWER!
 Check power and ground for
proper polarity.