Installation and Operation Manual

MCT245 RECEIVER
3
circuitry. The RF section runs on
the 3.3V supply.
The MCT245 uses Frequency
Hopping Spread Spectrum
that uses 16 channels for
any hop mode, between
2.407GHZ and 2.470GHZ, with
1MHZ resolution.
The receivers are matched
to the transmitters to use the
same channels and sequence
as the transmitter’s signals.
The MCT245 controls
outputs which can operate
relays, hydraulic valves, lights,
or other similar load devices,
according to customer
requirements.
Where Used
Typical applications for
the MCT245 are to
controlling valves, relays and
lights on agricultural
equipment,
construction equipment, and
other similar equipment.