User's Manual

Page 86 of 105 User Manual | SRU-8X1X RFID Reader 18000-63
Doc No. 47000001740
|
Version 01
|
2018-12-11
|
released
Confidential
14.8.2 Copy Parameter Set
The Copy parameter set allows one parameter set to be copied into another.
ᬇ
Source
parameter set
selects the parameter set to be copied
ᬈ
Target
parameter set
selects the parameter set into which the source parameter set is to be copied
ᬉ
Copy copies the parameter set
Ź Click Copy.
ۆ On successful completion of the copy operation, the Copy button briefly glows
green and a corresponding message is displayed in the status field.
ۆ If there is an error, the Copy button glows red, an error pop-up message
appears and a warning is shown in the status field.
ᬊ
shows the progress of the copying process
14.8.3 Change Reader Parameter
Change reader parameter allows to change all reader settings using their respective configuration IDs.
Figure 48 Expert settings 2: change reader parameter
ᬅ
Parameter
ID
selects the parameter ID
ᬆ
Parameter
value
shows or sets the parameter value
The value is either decimal or hexadecimal, it is possible to switch between dec and
hex.
ᬇ
Active
parameter
set
shows the current active parameter set
ᬈ
Get
reads the value of the current parameter set of the reader and shows it at ᬆ
ᬉ
Set
writes the parameter value (ᬆ) into the selected parameter ID (ᬅ)