User's Manual

Page 82 of 105 User Manual | SRU-8X1X RFID Reader 18000-63
Doc No. 47000001740
|
Version 01
|
2018-12-11
|
released
Confidential
Expert Settings 1
The ReaderStart SW is a powerful tool for the reader configuration. It allows the reader to be customized to
any application. The Expert settings 1 and 2 allow the reader's RF interface and communications profile to
be optimized to the tag so that the reader is optimally customized to the application.
There are eight parameter sets available for saving the reader configuration. It is possible to save all settings
for the transmission power, the antenna multiplex configuration, the RF settings and the air interface
parameters.
Other parameters can be changed in Expert settings 2.
Ź For more information about the individual parameters, refer to Reader Configuration Manual for
SRU-8X1X RFID Reader 18000-63.
Figure 45 Expert settings 1
ᬅ
Parameter Set selects a parameter set
ᬆ
Get reads the current settings of the selected parameter set in the system
ᬇ
Set sets the parameters
ᬈ
Enabled activates/deactivates the possibility to make changes in the port
ᬉ
Power changes the power on the port (ERP)
ᬊ
dBm/W switches between dBm and W
ᬋ
Port power shows the selected power on the port
ᬌ
Cable attenuation selects cable attenuation in the range between 0 and 63.75 dB
ᬍ
Antenna type selects the antenna type between pre-defined and custom antennas
If the pre-defined antenna is selected, the ReaderStart SW sets the antenna
gain to the maximum value permitted for this antenna. If Custom antenna is
selected, it is possible to freely set the gain and power.