User's Manual

Page 58 of 105 User Manual | SRU-8X1X RFID Reader 18000-63
Doc No. 47000001740
|
Version 01
|
2018-12-11
|
released
Confidential
14.1.1.2 Loading Factory Default Settings
When resetting the reader to factory default, the ReaderStart SW sends out a UDP broadcast cmd. It is only
possible 30 seconds after power rebooting.
Note that this command also resets the Linux module settings, such as Linux password,
network name, IP address, deactivates the auto start of the apps etc.
1. In the Ethernet section, click Search for Readers.
2. Select the reader onto which you would like to load the factory default settings.
3. Right-click on the reader.
ۆ The following pop-up message appears:
4. Click Load factory defaults on this Reader.
ۆ The pop-up message Are you sure to load factory defaults on this reader appears.
5. Click Yes to set the reader to the factory default settings.
Click No to cancel.
ۆ If you have clicked Yes, another pop-up window appears:
6. Click Start.
ۆ A pop-up message Are you really sure to load factory defaults on this reader appears.
7. Click Yes to set the reader to the factory default settings.
ۆ The status messages informing about the progress of the reset process are shown in the Status field of
the pop-up window, see examples in the figure above.
8. After the factory default settings have been loaded onto the reader, click Close.