User Manual

Kapsch TrafficCom AG
Page 48 of 58 Installation Manual | SRU-8100 RFID Reader 18000-63
Doc No. 47000001169 | Version 01 | 2014-11-03 | released
47000001169-Ins-01
Selecting commands from the ACTION list
The commands defined in ActionlistAction.xml are now available in the menu item Action
By pressing „Add action“ the commands are written in the chronological list within the reader device. If
successful, the status window prints GPIOAddActionToActionlist (9): Successfully acknowledged.
Assigning the Actionlist to the respective inputs
The right side of the GPIO functions tab within the section Assign input to Actionlist allows the
assignment of action list to the respective physical input ports. The assignment gets finally active by
choosing Assign to rising edge or Assign to falling edge. Please note the respective acknowledgement in
the status window.
Note: The Action List is only capable to perform basic logic operations. A real whitelist handling based on the
EPC values of tags and their assignment to output functions is not possible.
7.6 Expert settings 1
The ReaderStart v2 software is a powerful tool for configuration of the reader. It allows the reader to be
customized to any application. The expert settings 1 and 2 allow the reader's RF interface and
communications profile to be optimized with respect to tag reading performance.
There are eight parameter sets available which are stored inside the reader device. The settings are able to
be changed via the ReaderStart v2 software. Those settings allow a modification of the RF parameters to be
used in the air-interface communication, See section [2] Configurational Manual for more information about
the individual parameters.