User Manual

Kapsch TrafficCom AG
Installation Manual | SRU-8100 RFID Reader 18000-63
Doc No. 47000001169 | Version 01 | 2014-11-03 | released
Page 31 of 58
If there is the need to recreate the original layout of the program in respect of window size and sequence of
tabs, this can be achieved by means of the Reset layout menu item.
The Firmware Update item permits the update of the reader firmware. The window that opens shows the
version currently active in the reader. After selection of a firmware file, this version is shown in the next line.
Pressing the Update button starts the procedure. The progress is shown in the Update progress ar. After
successful update the reader must be restarted, either by pressing the Restart button or by switching the
power supply off and on again.
Figure 12 Updating the firmware
The reader has an integral clock which can deliver the time stamp for a tag operation. This clock is set using
the Date and time settings in the menu. When this menu item is opened, it automatically reads the current
date and time from the reader and compares it with the date and time from the host computer. The date and
time of the host computer can now be loaded to the reader by pressing the Set system date and time on
Reader button. There is also the possibility to set the reader date and time manually and load it to the
reader. This is done by entering the desired date and time on the reader side and pressing the Set adjusted
system date and time on Reader button. The status line indicates which action was just executed and
whether the action was successful.
Figure 13 Setting the date and time