User Manual

Kapsch TrafficCom AG
Page 22 of 58 Installation Manual | SRU-8100 RFID Reader 18000-63
Doc No. 47000001169 | Version 01 | 2014-11-03 | released
47000001169-Ins-01
6.4 Antenna Connection (ANTx)
The activation and evaluation can be performed using the software ReaderStart v2, with the DLL supplied,
or by access to the reader protocol.
Note: Please only use cable suitable for the impedance (50 Ohm), as otherwise the performance of the
reader will be severely limited by the mismatch. If the mismatch is large, the reader may indicate a fault.
6.5 LED
The reader has a 2-colour LED for the indication of the operating state. The table below shows the colors
used and the related operating state. When red and green is lit, the visible indication is orange.
Red Green Operating state
X flashes approx. every 8 seconds Error during initialization
X X Unit is booting
Flashes approx. every 8 seconds X Normal operation with heartbeat
Table 9 Indication of the operating states by the LED
6.6 Buzzer
Furthermore the reader is also fitted with a buzzer which, in addition to the LED, indicates successful booting
(1 x short) or an error (2 x long).