User Manual

Kapsch TrafficCom AG
Installation Manual | SRU-8100 RFID Reader 18000-63
Doc No. 47000001169 | Version 01 | 2014-11-03 | released
Page 17 of 58
5 Installation
5.1 Selecting the installation site
When the connectors are plugged in, the device satisfies the protection class IP65. When selecting the
installation location, make sure there is sufficient space around it for appropriate dissipation of the heat
generated by the device. Do not install it close to external sources of heat. The maximum operating
temperature listed in the data sheet must not be exceeded. The support surface must have a sufficient load-
bearing capacity/strength.
5.2 Installing the reader
The device has threaded holes at the rear for attaching the reader. The dimensions of the holes pattern can
be found in the drawing below. For ease of installation a bracket is available as an accessory, which offers
the option of mounting on a mast or wall.
Figure 2 Bottom side of the reading and mounting holes