User Manual

Kapsch TrafficCom AG
Page 14 of 58 Installation Manual | SRU-8100 RFID Reader 18000-63
Doc No. 47000001169 | Version 01 | 2014-11-03 | released
47000001169-Ins-01
FCC marking for the RFID reader with type designation "US":
The reader with the identifier "US" are designed to operate under FCC Part 15 and are listed under FCC
ID "XZU" on the FCC website.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and, (2) This device must accept any interference
received including interference that may cause undesired operation.
Modifications or conversions which are carried out on this unit without the express permission
of KTC may invalidate the FCC permit for the operation of this unit.
Note: To meet part 15 of the FCC regulations in the United States, the system must be properly installed to
guarantee adherence to the certification regulations according to part 15. The operator and the specialist
company which carries out installation are responsible for ensuring that only certified systems are used in the
United States.
Note: Following corresponding tests, it has been ascertained that this unit adheres to the limit values for
class B digital units in accordance with part 15 of the FCC regulations. These limit values are intended to
provide private user's systems with appropriate protection against harmful radio interference. This unit
generates and uses energy in the radio frequency range and is also able to radiate this; if it is not installed
and used in accordance with the regulations, the unit may cause harmful radio communication interference.
However, there is no guarantee that interference will not occur in a specific system. If this unit causes harmful
radio or television reception interference, which can be ascertained by switching the unit on and off, we
recommend that the user attempts to rectify this interference via one or more of the following measures:
- Realign the receive antenna or change its position.
- Increase the distance between the unit and the receiver.
- Plug the unit into a socket in a current circuit other than that to which the receiver is connected.
- Seek advice from the retailer or an experienced radio/television technician.
Warning regarding exposure to RF radiation
Ensure a minimum clearance of 20 cm between the antenna and the human body, and comply with the
operating instructions for RFID antennas. In some circumstances, heart pacemakers may suffer interference
if wearers are close to the antenna when the unit is in operation (reader and antenna). In case of doubt, the
people affected are requested to contact the manufacturer of their pacemaker or their doctor.
The reader output power must be reduced as a function of the antenna cable length and the antenna gain.