User Manual

Kapsch TrafficCom AG
Page 12 of 58 Installation Manual | SRU-8100 RFID Reader 18000-63
Doc No. 47000001169 | Version 01 | 2014-11-03 | released
47000001169-Ins-01
3 Safety instructions / information
Before starting installation work or replacing the unit, the accompanying manual must be read
carefully and its contents understood.
The detailed information in the data sheets and in this manual must be complied with carefully
during installation and operation of the reader!
The installation team must be properly qualified and familiar with the safety regulations
applicable in the country concerned.
Connection, installation and maintenance work, as well as all other work on the unit, may only be
carried out by properly qualified and trained employees.
The unit may only be used for the purpose intended by the manufacturer.
Unauthorized changes to the unit and the use of spare parts and peripheral devices which are
not sold or recommended by the manufacturer can result in fires, electric shocks and injuries.
Such actions therefore result in exclusion of liability and make the manufacturer’s
warranty/guarantee null and void.
The applicable version of the manufacturer’s warranty is that which was valid at the time of
purchase. We accept no liability for unsuitable manual or automatic adjustments made to the
unit's parameters and inappropriate use of the unit. Repairs may only be undertaken by
personnel authorized to perform them. Opening or attempting to repair the unit makes all
guarantee/warranty claims null and void! Improper work on the unit may jeopardize electrical
safety.
The manufacturer is not liable for accidents caused by the user opening the unit!
Always shut off power supplies during installation work with the equipment.
To avoid damage during transportation, the equipment must be transported in the original
package and not be exposed to rapid temperature variations, direct sunshine, or extreme
humidity.
Cables are handled mainly during the installation. Consider the following: Handle cables
carefully so that the insulation or shield is not damaged. Do not bend cables to a smaller radius
than the cable manufacturer has specified
Act to prevent tools from falling down of the working place onto the traffic lanes. Vehicles passing
under the gantry may be hit, with severe damage consequence.
When carrying out work on the unit, the valid safety regulations must be complied with.