Operations and Maintenance Manual

MPR 4.1

Reader

Operating Instructions

Confidential UM UM360479-100 Revision: Draft B4 Page 65 of 246

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM360479-100 REV B4 DRAFT WIP MPR-4.1 READER OPERATIONS AND MAINTENANCE MANUAL (002).DOCX 05/25/2022 11:18

Kapsch TrafficCom

Note 2: For the FDM protocols it is also necessary to set up Port frequencies for each Port, see

Frequency Selection, page 52

Note 3 : To support read/write operation it is necessary to configure the programming

configuration, see Programming tags, page 55

The following tabs will be used to create the frame sequence

• Tag Protocol panel: Seq #1 set to TDM, Seq#2 set to 6B, Seq#3 set to SYNC_1 and Seq#4 set

to 6C, all others set to empty.

• TDM panel: Channels 1 to 4 enabled sequentially in slots 1-4.

• 6B panel: Enable Channels 1 to 4 and select the appropriate Tag Read mode from the pull

down menu. Enable Dual Tag Preamble.

• 6C panel: Enable Channels 1 to 4 and select the appropriate Tag Read mode and over-air tag

masking from the pull down menus.

• Sync panel: Set the Reader-Reader sync parameters.

The detailed steps are as follows

1. Go to the Tag Protocol page Frame Sequence panel.

2. Set Seq #1 to TDM, Seq#2 to 6B, Seq#3 to SYNC_1 and Seq#4 to 6C.

Result: The following screen is shown as an example.

3. Click the TDM icon on the Frame Sequence panel to show TDM protocol settings.

Under the TDM Channel Firing Sequence panel, enable time slot 1 to 4 sequentially for the 4 channels.

Result The following screen is shown as an example.