Operations and Maintenance Manual

MPR 4.1

Reader

Operating Instructions

Confidential UM UM360479-100 Revision: Draft B4 Page 63 of 246

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM360479-100 REV B4 DRAFT WIP MPR-4.1 READER OPERATIONS AND MAINTENANCE MANUAL (002).DOCX 05/25/2022 11:18

Kapsch TrafficCom

Example 1: TDM only, read/write operation, four (4) lane plaza, not synced to another Reader.

Note 1: To use the sequence over the air it also necessary to set Ports to Active or Guard in the

Channel page, and to set appropriate attenuations for each Port

Note 2 : To support read/write operation it is necessary to configure the TDM programming

configuration, see Programming tags, page 55

The following panels in Tag Protocol page will be used to create the frame sequence

Tag Protocol panel: Set 1

sequence to TDM, all others are deselected

TDM panel: Enable channel 1 to 4 sequentially in time slot 1 to 4

The detailed steps are as follows

1. Go to Tag Protocol page Frame Sequence panel .

Result: The following screen appears.

1. Click the dropdown under icon.

Result: The following screen is shown as an example.

2. Select the TDM protocol.