Operations and Maintenance Manual

MPR 4.1

Reader

Operating Instructions

Confidential UM UM360479-100 Revision: Draft B4 Page 61 of 246

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM360479-100 REV B4 DRAFT WIP MPR-4.1 READER OPERATIONS AND MAINTENANCE MANUAL (002).DOCX 05/25/2022 11:18

Kapsch TrafficCom

Figure 3-2: Example Flexible Over the Air Frame Sequence (6B Weighted)

6C TID Read

Request

Sync Block

6B Triple Page

Request

6B Triple Page

Request

Sync BlockSync Block

Figure 3-3: Example Flexible Over the Air Frame Sequence with Dummy Frame

TDM Time Slots

Channel

Sequence A

6C TID Read

Request

Sync Block

6B Triple Page

Request

Dummy Frame ATA

Reader-supported protocols

The Reader supports the following protocols.

• TDM

• Title 21

• SeGo

• ISO-6B

• ISO-6C

• ATA

Dummy frame

A dummy frame is a software configurable time interval or block that the operator can insert in the

firing sequence. A dummy frame can be configured in one of the following two ways.

• Constant carrier is applied at the desired frequency and TX attenuation is enabled through the

web interface. The receivers are turned off.

• Both the transmitter and receiver are turned off.

Reader Frame Sequnce synchronization

The reader synchronizes air transmission timing to its own Ports, as well as to other readers, if these

readers are on the sync network and correctly enabled. To support reader sync at least 1 Sync frame

must be declared. For more information see page 74.

Sync frame