Operations and Maintenance Manual

_
MPR 4.1 Reader: Appendix
Confidential UM UM360479-100 Revision: Draft B4 Page 217 of 246
© Kapsch TrafficCom Canada Inc. 2022
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM360479-100 REV B4 DRAFT WIP MPR-4.1 READER OPERATIONS AND MAINTENANCE MANUAL (002).DOCX 05/25/2022 11:18
Kapsch TrafficCom
Command
How to execute
Who can
execute
Parameter
Name
Default Value
Parameter
Range
Purpose of command
(make sure the
TTO values of all
IRIF readers are
the same)
Enter a time, in
milliseconds, in
field.
exceeded before a reply is
seen the reader will assume
the other side is not awake.
This sets the threshold for
determining an IR network
problem and triggers a
switchover if enabled.
Inter-Reader
alias
With Ethernet
communication
method enabled:
Enter IP address of
this Reader in field.
user with
Change
Configuration
permissions
READIP
192.168.0.151
N/A
Assign a unique IPv4 address
to the reader as a whole. This
address is used for inter-
reader communication (e.g.
inter reader voting). If there
is only one reader at a site,
this can be set to 0.0.0.0
Ethernet 2 IP
address
With Ethernet
communication
method enabled:
Enter IP address of
the left Reader in
field.
user with
Change
Configuration
permissions
PRIMIP
192.168.0.50
N/A
Assign a unique IPv4 address
to Ethernet 2 interface for
inter-reader voting. This
address should be provided
by the SI network planner.
MUST NOT BE ON THE SAME