Operations and Maintenance Manual

_
MPR 4.1 Reader: Appendix
Confidential UM UM360479-100 Revision: Draft B4 Page 168 of 246
© Kapsch TrafficCom Canada Inc. 2022
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM360479-100 REV B4 DRAFT WIP MPR-4.1 READER OPERATIONS AND MAINTENANCE MANUAL (002).DOCX 05/25/2022 11:18
Kapsch TrafficCom
Command
How to execute
Who can
execute
Parameter
Name
Default Value
Parameter
Range
Purpose of command
SNMP Traps
Toggle switch to
enable /disable
SNMP trap.
user with
Change
Configuration
permissions
CSTRAP
0
0 - 1
Configure whether the
reader sends SNMP traps on
status changes.
TRAPIP 1
Type in a SNMP
Trap destination IP
address and port in
field.
user with
Change
Configuration
permissions
TRAPIP
Ip 0.0.0.0
and
port 162
N/A
Sets IP address and Port of
the 1
st
SNMP Trap
destination.
Used to send a trap to this
destination. Set to 0.0.0.0 to
disable this destination. By
default traps are sent to port
162.
TRAPIP 2
Type in 2
nd
SNMP
Trap destination IP
address in field.
user with
Change
Configuration
permissions
TRAP_2
Ip 0.0.0.0
and
port 162
N/A
Send a simultaneous trap to
this 2
nd
destination. Set to
0.0.0.0 to disable this
destination.