Operations and Maintenance Manual

MPR 4.1

Reader Maintenance Instructions

Confidential UM UM360479-100 Revision: Draft B4 Page 105 of 246

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM360479-100 REV B4 DRAFT WIP MPR-4.1 READER OPERATIONS AND MAINTENANCE MANUAL (002).DOCX

05/25/2022 11:18

Kapsch TrafficCom

9. Enter the Reader IP Address of the right Reader.

To ensure correct operation it is also necessary to:

10. On the Tag Protocol page TDM Tag Programming panel (see Programming on page 55) ensure that:

• TMP and TCP are enabled

• The Plaza IDs of all Readers at the plaza match

• The Reader ID for each Reader is different.

11. Configure the Reader clocks in the IR network to have the same time (see NTP Server, page 132).

12. From the Channels web page, ensure all channels covering one direction of traffic have the same (voting)

Group ID.

Figure 5-15: Sample inter-reader setup

Configuring Legacy Cross Reader Algorithm (CRA) communication

Prerequisites: Connect a service laptop to the Lane Controller port to access the web interface.

Refer to Connecting a service laptop to the Reader, page 34.

1. Go to the Lane Assignment web page.

2. Select Legacy CRA for Inter-Reader Communication Method

Result: The following screen appears.