Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader 2.4 Operating Instructions
Confidential UM 360467-110 Revision: B Page 85 of 247
© Kapsch TrafficCom Canada Inc. 2021
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01
Kapsch TrafficCom
Command
How to execute
Who can
execute
Prmtr.
Name
Default Value
Prmtr.
Range
Purpose of command
Enable TMP
On the Traffic
Management
Programming (TMP)
panel on the Tag
Protocol page, check
Enable switch
User with
Change
Configuration
permission
TMP___
1
0-1
Enable means write a timestamp and Reader ID in
transponder memory. Disabled means the reader
does not update those fields.
Reader ID
On the Traffic
Management
Programming (TMP)
panel on the Tag
Protocol page:
Enable or disable the
Reader ID switch.
User with
Change
Configuration
permission
rw_RID
1
0-1
Determines whether or not to program the TM-
DATA reader ID field of the tag's R/W area
Reader ID
On the TDM Tag
Programming panel on
the Tag Protocol page:
Enter a value in the
Reader ID field.
Note: Make sure a
unique Reader ID is used
when there are multiple
readers at a plaza.
User with
Change
Configuration
permission
RID___
0
min: 0
max: 4095
Use to enter a value which is written into the
transponder if either Traffic Management or Cross
Reader Algorithm (Classic) is enabled.