Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader 2.4 Operating Instructions
Confidential UM 360467-110 Revision: B Page 84 of 247
© Kapsch TrafficCom Canada Inc. 2021
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01
Kapsch TrafficCom
Command
How to execute
Who can
execute
Prmtr.
Name
Default Value
Prmtr.
Range
Purpose of command
Agency 1 Sub-Mask
(dec)
On the 6C Programming
panel on the Tag
Protocol page
With 6C Sub-Mask
enabled, enter 6C
Agency ID Sub-Mask.
User with
Change
Configuration
permission
6CSMAI
0
0-4294967295
Specify the 6C Agency ID Sub-Mask to use. Please
specify a (maximum of 32-bits) value in decimal. An
Agency ID Mask value of 0 represents no mask in
effect. Note: The maximum allowed value is
determined by the selected mask.
Agency 2 Sub-Mask
(dec)
On the 6C Programming
panel on the Tag
Protocol page
With 6C Sub-Mask
enabled, enter 6C
Agency ID Sub-Mask.
User with
Change
Configuration
permission
6CSMA2
0
0-4294967295
Specify the 6C Agency ID Sub-Mask to use.
Agency 3 Sub-Mask
(dec)
With 6C Sub-Mask
enabled, enter 6C
Agency ID Sub-Mask.
User with
Change
Configuration
permission
6CSMA3
0
0-4294967295
Specify the 6C Agency ID Sub-Mask to use.
TDM Read-Only
Mode
On the TDM Tag
Programming panel on
the Tag Protocol page,
check Enable switch
User with
Change
Configuration
permission
RDONLY
0
0-1
Controls whether the reader writes or does not
write to TDM tags.