Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader 2.4 Operating Instructions
Confidential UM 360467-110 Revision: B Page 78 of 247
© Kapsch TrafficCom Canada Inc. 2021
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01
Kapsch TrafficCom
Command
How to execute
Who can
execute
Prmtr.
Name
Default Value
Prmtr.
Range
Purpose of command
SNMP Trap
Destination #2
On the SNMP panel of
the General page:
Type an IP address and
port in the TRAPIP 2
address field
User with
Change
Configuration
permission
TRAP_2
Ip 0.0.0.0
and
port 162
N/A
Used to define IP address and port of Trap
destination #2
SNMP Trap
Destination #3
On the SNMP panel of
the General page:
Type an IP address and
port in the TRAPIP 3
address field
User with
Change
Configuration
permission
TRAP_3
Ip 0.0.0.0
and
port 162
N/A
Used to define IP address and port of Trap
destination #3
Switchover on Serial
Link Down
On the Switchover panel
of the General page:
With Serial
communications
enabled, select the
Switchover on Serial Link
Down switch.
User with
Change
Configuration
permission
SOSERL
0
0-1
Disabled: switchover does not occur when the Serial
link is down.
Enabled: Enable means switch-over to secondary
side if the reader determines a serial link to the lane
controller is down. Has no meaning on secondary
side.
Note: If enabled, you MUST also disable all unused
COM ports (see SERIAL tab) as well as unused LC
destinations (see LC tab).
Switchover on
Ethernet LC Link
Down
On the Switchover panel
of the General page:
With Ethernet LC
communications
enabled, select the
Switchover on Ethernet
LC Link Down switch.
User with
Change
Configuration
permission
SO_ETH
0
0-1
Disabled: switchover does not occur when the
Ethernet LC link is down.
Enabled: to enable the Reader to switchover from
the primary side to the secondary side when an
Ethernet link to the LC is down.