Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader 2.4 Operating Instructions
Confidential UM 360467-110 Revision: B Page 77 of 247
© Kapsch TrafficCom Canada Inc. 2021
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01
Kapsch TrafficCom
Command
How to execute
Who can
execute
Prmtr.
Name
Default Value
Prmtr.
Range
Purpose of command
Reader IP Address
On the Network panel of
the General page:
Type an Reader port IP
address in Reader IP
Address field.
User with
Change
Configuration
permission
LETHIF
192.168.1.50
N/A
Set the IPv4 address of the ETHERNET 1 interface
Reader IP Subnet
mask
On the Network panel of
the General page:
Type the subnet mask
address in the Reader IP
Subnet Mask field
User with
Change
Configuration
permission
LETHNM
255.255.255.0
N/A
Set the ETHERNET 1 interface Subnet mask
according to your LAN requirements.
Default Gateway IP
On the Network panel of
the General page:
Type an IP address in the
Default Gateway IP
Address field
User with
Change
Configuration
permission
DFGWIP
0.0.0.0
N/A
Set a gateway IPv4 address if needed by your LAN
requirements.
Set to 0.0.0.0 if not using a gateway.
SNMP Trap Enable
On the SNMP panel of
the General page:
Select SNMP Traps
switch
User with
Change
Configuration
permission
CSTRAP
0
0 - 1
Used to enable and disable SNMP traps
SNMP Trap
Destination #1
On the SNMP panel of
the General page:
Type an IP address and
port in the TRAPIP 1
address field
User with
Change
Configuration
permission
TRAPIP
Ip 0.0.0.0
and
port 162
N/A
Used to define IP address and port of Trap
destination #1