Operations and Maintenance Manual

JANUS

Multi-Protocol Reader 2.4 Operating Instructions

Confidential UM 360467-110 Revision: B Page 68 of 247

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01

Kapsch TrafficCom

3. Expand the TDM Channel Sequence Firing panel and confirm that each channel 1 to 8 is enabled in a

corresponding time slot 1 - 8.

Note: You can use the icon to reset the TDM channel firing sequence (enable slots 1 to 8 with

sequential channels 1 through 8).

Note: New for MPR 2.4, a TDM frame sequence can be as short as 1 time slot.

Example 2: TDM, 6C (6CTOC compliant), and 6B, two (2) Lane ORT with Shoulders (five (5) channels) with

five (5) channel scan) and synchronization between readers

Note: Unlike the previous example, for the FDM protocols it is also necessary to set up channel frequencies

for each channel, see Frequency Selection, page 60

The detailed steps are as follows.

1. Select the Channels page and set "Number of channels" to 5. This sets a 5 channel TDM scan, and

enables FDM channels 1 - 5.

Select the Tag Protocol page, and assuming TDM is already present, click the + icon and add 6B, click the + icon

and add Sync_1, and finally click the + icon and add 6C. The resulting frame sequence should appear as follows:

2. Select the 6B icon from the frame sequence, and expand the 6B Advanced panel., choose the desired

options. Enable Dual Tag Preamble.