Operations and Maintenance Manual

JANUS

Multi-Protocol Reader 2.4 Operating Instructions

Confidential UM 360467-110 Revision: B Page 62 of 247

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01

Kapsch TrafficCom

Enter the Plaza ID and Agency ID in the fields in the TDM Tag Programming panel.

The following fields should be enabled; if not, toggle them on.

• TC Date/Time

• R/W Format

• Lane number

Select the OBU Feedback check box to enable OBU (tag) feedback.

(Optional) Assign a Lane Number to each RF channel. When a transaction occurs between an OBU and a channel,

the Lane Number specified here will be written to the OBU read/write memory.

Configuring 6C tag programming for Toll Collection applications

The Reader can write data to a 6C tag as it passes through a toll plaza. The following procedure outlines how to

enable 6C tag programming and how to configure the data that is written to the tags.

1. In the 6C Programming panel, set the Enable toggle.

Result: The following screen appears:

Configuring OBU Feedback

This setting applies to the TDM Feedback transponder. This tag model has audible and visual (red, green, and

yellow) indicators that can be activated by the reader as the transponder crosses an antenna zone. TDM

Programming needs to be enabled for this functionality.

1. Toggle the “OBU Feedback” slider in the OBU Feedback panel.