Operations and Maintenance Manual

JANUS

Multi-Protocol Reader 2.4 Operating Instructions

Confidential UM 360467-110 Revision: B Page 61 of 247

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01

Kapsch TrafficCom

Programming tags

For certain tag protocols (TDM and 6C), the Reader can write data to a tag as it passes through a toll collection

point. The following procedures outlines how to enable tag programming and how to configure what data fields

are written to the tags.

1. Under Tag Protocols, select TDM. Scroll down to the TDM Tag Programming panel.

To confirm TDM tag programming is enabled, ensure that "Enable" is toggled on.

To disable TDM tag programming, toggle the slider off.

Configuring TDM tag programming for Traffic Management Applications

1. From the TDM Tag Programming panel, select the Enable TMP switch position ON.

Select the Reader ID switch to enable writing the Reader ID to tags.

Enter a unique Reader ID.

Select the TM Date/Time switch to write the Reader TM time to tags.

Example: The following screen is shown.

Note: Reader ID is required to support Badger Style CRA operation when there are multiple adjacent

readers. This will reduce duplicate tag Vote reports to the lane controller.

Configuring TDM tag programming for Toll Collection applications

1. From the Toll Collection Programming (TCP) panel, ensure Enable is toggled on.

Result: The following screen appears: