Operations and Maintenance Manual

JANUS

Multi-Protocol Reader 2.4 Operating Instructions

Confidential UM 360467-110 Revision: B Page 58 of 247

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01

Kapsch TrafficCom

Review the settings.

Click to apply the settings.

Channel configuration

The presence or absence of MRFM-S modules in the rack and their assigned status is provided by the Channels

page. Select this page and declare the "RF State" state of each physical slot in the reader. By default, all

channels are set to Active. Channel 1 is the leftmost slot in the reader RF rack. Those RF channels that are

known to be empty, should be marked on the Channels page as “NoModule” in order to avoid the reader

assuming there is a RF module communications fault.

A voting time is specified for each channel, which controls the timing of the "Vote" report to the lane controller.

A separate voting time is configurable for bumper mount (LPT/FME tags). There is one Vote report per tag

passage to the lane controller, even when cross channel reads occur. Dynamic voting can be enabled (toggle the

Advanced slider), which lets the reader chose an optimum voting time for that particular channel based on

recent tag traffic in that channel.

Sample "Channels "page: