Operations and Maintenance Manual

Confidential UM 360467-110 Revision: B Page 4 of 247

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01

Kapsch TrafficCom

MODEL 802295A-A PART 2 of 2 RF AMPLIFIER ASSEMBLY

The amplifier is only approved for use with the corresponding module (part 1 of this

model)

115VAC – 230VAC, 2A, 60Hz

Note: IEC 60950-1 and/or EN60950-1, First Edition, Information Technology Equipment –

Safety – Part 1: General Requirements require that this equipment must be located in a

RESTRICTED ACCESS LOCATION (RAL). Only authorized personnel can have access to the

equipment.

Note: This equipment has been tested and found to comply with the limits for a Class A

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference when the equipment is operated in a

commercial environment. This equipment generates, uses, and can radiate radio

frequency energy and, if not installed and used in accordance with the instruction manual,

may cause harmful interference to radio communications. Operation of this equipment in

a residential area is likely to cause harmful interference in which case the user will be

required to correct the interference at their expense.

Changes or modifications not expressly approved by Kapsch TrafficCom could void FCC

compliance and the authority to operate the equipment.