Operations and Maintenance Manual

Confidential UM 360467-110 Revision: B Page 3 of 247

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01

Kapsch TrafficCom

FCC License Notice:

This equipment emits RF signals. In order to operate this equipment the customer must

obtain a separate FCC Part 90 Site license for each location. In addition, the FCC ID

component identification JQU802295A, or JQU802295A-A or JQU802870 must appear on a

label on the front of the RF Modules installed in these Readers.

Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the

following two conditions: (1) this device may not cause harmful interference and (2) this

device must accept any interference received, including interference that may cause

undesired operation.

The power output of a module at ambient (P

out(amb)

) shall be constrained using internal or

external Tx attenuation so that the following is satisfied:

out(amb)

<= 43.77 dBd - G

fund

;

Where G

fund

is the net gain from antenna connector on the RF module to the antenna radiated

signal. The antenna gain is expressed in dBd.

The Power output from the amplifier assembly of a module plus external amplifier at ambient

(AmpOut(amb)) shall be constrained using module internal TX attenuation so that the following

are both satisfied:

AmpOut(amb): <= 39 dBm; and

AmpOut(amb): <= 43.77 dBmd - Gfund;

where Gfund is the net gain at fundamental frequency from the antenna connection on the

amplifier assembly to the antenna radiated signal where the antenna gain is expressed in dBd.

The net gain at the second harmonic from the antenna connection on the amplifier assembly

to the antenna radiated signal shall be:

G2nd <= Gfund - 14dB.