Operations and Maintenance Manual

JANUS

Multi-Protocol Reader 2.4 Appendix

Confidential UM 360467-110 Revision: B Page 219 of 247

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01

Kapsch TrafficCom

Appendix A Miscellaneous

Using PuTTY to connect to the DIAGNOSTIC PORT

1. Launch PuTTY.

Select Serial as your Connection Type.

Select the computer COM port that is connected to the Diagnostic Port.

Enter 115200 in the Speed text box.

Click Open.

Result: The following configuration screen appears.

Press Enter a few times until the login prompt appears.

Using HyperTerminal to connect to the DIAGNOSTIC PORT

1. Go to Start → Run.

Type hypertrm, and then click OK.

In the Connection Description pop-up, enter a session name and then click OK.

In the Connect To pop-up, select the COM port that is connected to the Diagnostic Port from the Connect Using

drop-down box.

Click OK.