Operations and Maintenance Manual

JANUS

Multi-Protocol Reader 2.4 Maintenance Instructions

Confidential UM 360467-110 Revision: B Page 208 of 247

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01

Kapsch TrafficCom

Rebooting the CTM

This procedure outlines two ways of rebooting the CTM

Rebooting from the reader web interface (preferred method)

Prerequisites: Accessing the Reader web interface, page 42.

1. From the Dashboard page, click the button and confirm the operation.

Result: The CTM starts to reboot.

Rebooting using CTM ON/OFF switch

1. Set the CTM ON/OFF switch to OFF.

After five seconds, set the CTM ON/OFF switch back to ON. The CTM POWER LEDs immediately illuminate solid

green. After 90 – 120 sec., the CTM STATUS LEDs illuminate their normal state (see LED Status, page 183).

Configuring events that cause a switchover

Redundant Readers need to be configured in order to:

• Determine whether the Reader switches over when there is a failure

• Determine what failures cause a switchover

Prerequisites: The primary and secondary sides are both powered up. Change Configuration permissions.

Manually select the active side and disable switchover

CAUTION:

If the primary or secondary side is forced active via the SPM redundancy

mode switch and that side fails, the Reader will not switch to the other

side and data could be lost.

1. Set the toggle switch on the SPM to the side to stay active, either SECONDARY or PRIMARY.

Result: This side is now active and no switchover will occur unless a failure occurs.

Letting the Reader automatically choose the active side

1. Set the SPM toggle switch to AUTO.

Result: The primary side is now active by default, until a primary failure occurs.

Configuring the Reader to switch over automatically when an LC link is down

1. From the home page, click the Lane Controller button to get to the Lane Controller page: