Operations and Maintenance Manual

JANUS

Multi-Protocol Reader 2.4 Maintenance Instructions

Confidential UM 360467-110 Revision: B Page 197 of 247

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01

Kapsch TrafficCom

Testing the MRFM-S slots

The following test is to verify that all MRFM-S slots in the upper portion of the Reader rack are functional.

Prerequisites: Accessing the Reader web interface, page 42. One functional MRFM-S is installed in the RF slot 1

of the Reader rack.

Note: All eight channels in the frame sequence configuration must be enabled to fire, otherwise this test will

not work.

1. From the dashboard, select the Channels page.

Result: The following screen appears.

Set “Number of channels” to 8 if not currently set to 8.

Set the channel number (where the RF module is installed) to Active.

Ensure that the DATA LED on the RF module illuminates solid green.

From the Channel page, select Offline from the RF State drop-down box.

Ensure that the DATA LED on the RF module is off.

Move the RF module to the next slot and repeat steps 3 through 6.