Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader 2.4 Maintenance Instructions
Confidential UM 360467-110 Revision: B Page 183 of 247
© Kapsch TrafficCom Canada Inc. 2021
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01
Kapsch TrafficCom
LED Statuses
The following table gives an overview of all the LEDs on the Reader. See the Troubleshooting Trees beginning on
page 185 to resolve any issues.
Table 6-1: CTM LED states explained
CTM LEDs
LED
State
Meaning
CGC
solid green
CGC is functional
solid red
CGC has failed
solid amber
CGC suspended (i.e., Frame Sequence empty)
MC
blinking green
MC is functional
solid green or solid red
MC has failed
SYNC
On the
‘Active’
CTM
solid green
Reader is synchronized with other readers on the sync
network.
flashing red
Reader out of sync with other readers on the sync
network, or,
No activity detected from other readers on the sync
network
flashing green/orange
Reader is out of sync with other readers on the sync
network and attempting recovery
Off
Synchronization is disabled
On the
‘Inactive’
CTM
solid green
The inactive side is in sync with the Active side
flashing red
The inactive side is out of sync with the Active side, or no
activity is detected by the active side on the internal sync
line.
flashing green/orange
The inactive Side is out of Sync with Active side and is
attempting recovery.
off
N/A
ACTIVE
solid green
The CTM is active and in control. This indicates if the
primary or secondary side is active.
solid red
The CTM is not active
POWER
solid green
CTM is receiving power from PSM
off
CTM is not receiving power from PSM, or,
CTM reset switch is OFF