Operations and Maintenance Manual

JANUS

Multi-Protocol Reader 2.4 Maintenance Instructions

Confidential UM 360467-110 Revision: B Page 167 of 247

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01

Kapsch TrafficCom

Configuring synchronization

Prerequisites: Refer to Accessing the Reader web interface, page 42. See also Synchronization rules on page 67.

Note: Reader synchronization is also enabled remotely by the LC.

Example: TDM only 2 Lane ORT with Shoulders (5-Channel scan) and synchronization.

• Channels page: set number of channel to 5

• Tag Protocol page: Delete all protocols, then add TDM protocol followed by a Sync_1 block.

• Sync panel: Verify the Sync parameters.

The following procedure indicates how to compose the given example.

1. Select the Channels page and set Number of channels field to 5.

Result: The following screen appears.

2. Select the Tag Protocol page from the banner menu (or click on one of the banner protocol icons), and

delete all protocol items via selecting .

Result: The following screen appears.

3. Click + and add the TDM protocol, then + again to add a sync block.

Result: The following screen is shown as an example.