Operations and Maintenance Manual

JANUS

Multi-Protocol Reader 2.4 Maintenance Instructions

Confidential UM 360467-110 Revision: B Page 151 of 247

All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.

FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01

Kapsch TrafficCom

5. INSTALLATION

Introduction

The Reader is shipped with the required power, communications, and logic modules. The Lane Kits are supplied

separate from the Reader.

An antenna, an MRFM-S, a feedline cable adapter, and a circulator comprise a Lane Kit.

After the equipment is installed, the Reader must be configured via the CTM browser interface. After

configuration is complete, the Reader configuration needs saving (see Saving the Reader configuration, page

212) for future reference.

The toll agency and/or system integrator must select the configuration and setup that is suitable for the

application and the desired system performance.

CAUTION:

Improper modification of configuration parameters may adversely

affect system operation. The default values may not be appropriate

for the specific application. It is the system integrator’s responsibility

to tailor the configuration parameters to the specific operating

environment.

CAUTION: Redundant Reader

Please be aware of how Configuration Alignment automatically

copies Primary side settings to the Secondary CTM. Refer to

Configuration Alignment, page 69.