Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader 2.4 Maintenance Instructions
Confidential UM 360467-110 Revision: B Page 149 of 247
© Kapsch TrafficCom Canada Inc. 2021
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01
Kapsch TrafficCom
St
Transaction status.
Pgm indicates successful transponder programming.
PU indicates transponder programming status is Unknown (tag left zone before verify could
complete).
PF indicates transponder was not programmed successfully.
Read indicates the Reader is in read only mode.
CrossR indicates an informational report (an adjacent reader reported the passage).
Txn
Transaction number. Note that transaction numbers may appear to skip when using 2 or more
Readers with Ethernet connection between them.
Ag
Agency ID of transponder.
Sn
Serial number of transponder.
AHs
“Assigned Handshake count” The number of handshakes (Reads) that occurred on the assigned
channel up to voting time. (note RPVs currently count as 1)
THs
For a TDM Transaction:
The total number of handshakes (Reads) that occurred on the assigned channel for the previous
TDM transaction on the same RF channel. (Note RPVs currently count as 1). A value of 00 is
reported after reset or power-up. A value greater than 99 is indicated as 99.
For a Non-TDM Transaction:
The total number of handshakes (Reads) that occurred on the assigned channel for the previous
non-TDM transaction on the same RF channel. A value of 00 is reported after reset or power-up. A
value greater than 99 is indicated as 99.
GUARD
Shown for a transaction assigned to a RF channel set to Guard. These transactions will always
show !LC to indicate that no report for the LC is generated. Tag programming is disabled for Guard
channels.
?LA
In a POST report, indicates that a lane assignment change was detected between the voting time
report and the post time report. May be an indication that voting time is not optimal.
?PS
In a POST report, indicates that a programming status change was detected between the voting
time report and the post time report.
>LC
>LC indicates transaction is to be reported to lane controller (connection present or not). Only
appears on the Active CTM
!LC
!LC indicates transaction is suppressed (e.g. GUARD lane or CrossR transactions or CTM is
Inactive).
Cx-HS
HS tag handshakes seen up to voting/post time on the MasterSet center Reader. Note: Does not
appear unless inter-reader communication is configured.
Lx-HS
HS tag handshakes seen up to voting/post time on the MasterSet left Reader. Note: Does not
appear unless inter-reader communication is configured.
Rx-HS
HS tag handshakes seen up to voting/post time on the MasterSet right Reader. Note: Does not
appear unless inter-reader communication is configured.