Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader 2.4 Operating Instructions
Confidential UM 360467-110 Revision: B Page 125 of 247
© Kapsch TrafficCom Canada Inc. 2021
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01
Kapsch TrafficCom
Command
How to execute
Who can
execute
Prmtr.
Name
Default Value
Prmtr.
Range
Purpose of command
Voting Delay Gap
Scaling Factor (%)
On the TDM Early Read
Logic panel on the Lane
Assignment page,
Enter value in Voting
Delay Gap Scaling Factor
field,
User with
Change
Configuration
permission
ERDVSF
100
0 - 500
Specifies the voting delay scaling factor to apply
Minimum Post Gap
HS Ratio (0-100%)
On the TDM Early Read
Logic panel on the Lane
Assignment page,
Enter value in Minimum
Post Gap HS Ratio field,
User with
Change
Configuration
permission
ERDHSR
50
0 - 100
Specifies the minimum post gap to cumulative HS
ratio (e.g. 50% means at least half of the HS on any
channel must be after the RF gap).
Enable Low Read
Logic
On the TDM Low Read
Logic panel on the Lane
Assignment page, check
the Enable switch
User with
Change
Configuration
permission
LWREAD
0
0 - 1
Delays voting if a long RF gap right before voting is
detected.
Max Delay (ms)
On the TDM Low Read
Logic panel on the Lane
Assignment page,
Enter value in Max
Voting Delay field
User with
Change
Configuration
permission
LRDMAX
1000
1 - 10000
Specifies the maximum time in milliseconds allowed
to delay voting
Min Gap Size (ms)
On the TDM Low Read
Logic panel on the Lane
Assignment page,
Enter value in Min Low
Read Gap Size field
User with
Change
Configuration
permission
LRDGAP
50
1 - 10000
Specifies the minimum allowed gap size