Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader 2.4 Operating Instructions
Confidential UM 360467-110 Revision: B Page 124 of 247
© Kapsch TrafficCom Canada Inc. 2021
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01
Kapsch TrafficCom
Command
How to execute
Who can
execute
Prmtr.
Name
Default Value
Prmtr.
Range
Purpose of command
Ethernet 2 IP
Address:
From the Inter-Reader
panel on the Lane
Assignment page, with
Ethernet communication
method enabled:
Type an ETHERNET 2
port IP address in the
Ethernet 2 IP Address
field..
User with
Change
Configuration
permission
PRIMIP
192.168.0.50
Primary
192.168.0.51
Secondary
N/A
Used to assign a unique IPv4 address (e.g.
192.168.0.50) to the right hand side (prime) side of
the reader.
Used to specify an appropriate ETHERNET 2 IP
address when configuring an IR network. Note: This
address should be provided by the SI network
planner.
Enable Early Read
Logic
On the TDM Early Read
Logic panel on the Lane
Assignment page, check
the Enable switch
User with
Change
Configuration
permission
EREAD_
0
0 - 1
Can improve TDM programming success rate by
detecting early reads and delaying voting according
to the extent (i.e., time gap) of the early read.
Max Delay (ms)
On the TDM Early Read
Logic panel on the Lane
Assignment page,
Enter value in Max
Voting Delay field
User with
Change
Configuration
permission
ERDMAX
1000
1 - 1000
Specifies the maximum time in milliseconds allowed
to delay voting
Min Gap Size (ms)
On the TDM Early Read
Logic panel on the Lane
Assignment page,
Enter value in Min Early
Read Gap Size field,
User with
Change
Configuration
permission
ERDGAP
50
1 - 10000
An early read Specifies the minimum allowed gap
size