Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader 2.4 Operating Instructions
Confidential UM 360467-110 Revision: B Page 109 of 247
© Kapsch TrafficCom Canada Inc. 2021
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01
Kapsch TrafficCom
Command
How to execute
Who can
execute
Prmtr.
Name
Default Value
Prmtr.
Range
Purpose of command
Select checkbox to
enable Ethernet and/or
Dual Ethernet for each
RF channel
Destination IP
Address and Port
On the LC Destination
panel on the Lane
Controller page:
Select Ethernet checkbox
and input ip address in
field.
User with
Change
Configuration
permission
LCIPPT
N/A
N/A
This specifies the destination IP address and port.
Dual Destination IP
Address and Port
On the LC Destination
panel on the Lane
Controller page:
In Advanced mode:
select Dual Ethernet
checkbox and input ip
address in field.
User with
Change
Configuration
permission
LC2IPP
N/A
N/A
This specifies the Dual Destination IP address and
port.
Tertiary Ethernet
Destination IP
Address (IREADs
only)
From the LC tab on the
Configure panel:
User with
Change
Configuration
permission
LC3IPP
N/A
N/A
This specifies the Tertiary Destination IP address and
port.
Note: Only IREAD reports are sent over this link.
Voting Report
On the LC Reporting
panel on the Lane
Controller page:
User with
Change
Configuration
permission
VOTRPT
1
0-1
Used to choose to send a voting report