Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader 2.4 Operating Instructions
Confidential UM 360467-110 Revision: B Page 105 of 247
© Kapsch TrafficCom Canada Inc. 2021
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01
Kapsch TrafficCom
Command
How to execute
Who can
execute
Prmtr.
Name
Default Value
Prmtr.
Range
Purpose of command
Sync. Recovery
Attempt Limit
From the Sync Advanced
panel of the Tag Protocol
page:
Enter attempt limit in
field.
User with
Change
Configuration
permission
SYNRTL
0
0 – 100
This value specifies how many Sync Recovery Time
Periods must expire before the reader will no
longer search/wait for sync before firing its tag
acquisition sequences independently of the reader
sync network. If set to zero, the Reader will always
wait for the Sync Recovery Time to expire before
firing its tag acquisition sequence.
Enable Custom Sync
Timing
From the Sync Advanced
panel of the Tag Protocol
page:
Set toggle switch to ON
to enable.
User with
Change
Configuration
permission
SYNCSE
0
0-1
Enables/disable custom sync timing.
Sync Search Time
(µs)
From the Sync Advanced
panel of the Tag Protocol
page:
With Custom Sync
Timing enabled,
enter sync search time in
us.
User with
Change
Configuration
permission
SYNSTO
100 µs
20 - 65535 µs
Specify how long the Sync function will search for
the synchronization signal in microseconds (µs)
before switching to recovery mode.
Sync Recovery Time
(ms)
From the Sync Advanced
panel of the Tag Protocol
page:
With Custom Sync
Timing enabled,
enter sync recovery time
in ms.
User with
Change
Configuration
permission
SYNRTO
20 ms
0 - 65535 ms
Specify how long the Sync function will attempt
synchronization recovery in the event that the
sync signal is not seen during the Sync Search
phase.
Note: It is recommended that this value be set to at
least 125% of the total multi-protocol tag
acquisition sequence.