Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader 2.4 Operating Instructions
Confidential UM 360467-110 Revision: B Page 104 of 247
© Kapsch TrafficCom Canada Inc. 2021
All information contained herein is proprietary to, and may only be used with express, written permission from, Kapsch TrafficCom Canada Inc.
FILE: UM 360467-110 REV B3 MPR 2.4 CLEAN.DOCX 03/02/2021 1:01
Kapsch TrafficCom
Command
How to execute
Who can
execute
Prmtr.
Name
Default Value
Prmtr.
Range
Purpose of command
Dummy Frame
Length
From the Dummy
Advanced panel of the
Tag Protocol page:
Enter frame length in the
field.
User with
Change
Configuration
permission
DUMTSD
500
per dummy
instance
(up to 4
instances):
500 - 32767
Specifies the duration of the Dummy (CW) timeslot.
Note: When combined with the Dummy Frame
Length Units parameter, below, the (min, max)
allowable Dummy Frame Length when CW is
enabled is (500 µs, 200 ms)
Dummy Frame
Length Units
From the Dummy
Advanced panel of the
Tag Protocol page:
Select the required
multiple from drop-
down list.
User with
Change
Configuration
permission
DUMTSU
x1 µs (0)
per dummy
instance
(up to 4
instances):
x1 µs (0)
x 100 µs (1)
Specifies the units to be used when specifying the
duration of the Dummy timeslot.
Note: When combined with the Dummy Frame
Length Units parameter, above, the (min, max)
allowable Dummy Frame Length when CW is
enabled is (500 µs, 200 ms)
Reader-to-Reader
Sync. Enable
From the Sync Advanced
panel of the Tag Protocol
page:
When Sync is selected in
frame sequence, Reader-
to-Reader sync will be
enabled automatically.
If Sync is deselected,
Reader-to-Reader sync
will be disabled
automatically.
User with
Change
Configuration
permission
RFSYNC
0
0 - 1
Controls whether RF transmission is synchronized
between adjacent readers.
Note: A sync cable to connect readers is required if
Reader-to-Reader sync is to be enabled.