Operations and Maintenance Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Maintenance Instructions
Confidential UM 360463-202: A12 (Draft) Page 175 of 291
© Kapsch TrafficCom Canada Inc. 2013
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict
confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or
used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24
Kapsch TrafficCom
Result: The following screen appears.
Configure how multiple transactions are reported to the LC:
 To send one transaction report per OBU to the LC without informing the LC of suppressed reports, select
Disabled from the Cross-Reader Reporting drop-down box.
 To send all transaction reports for an OBU to the LC, select Report All from the Cross-Reader
Reporting drop-down box.
 To send on transaction report per OBU to the LC and also inform the LC of suppressed reports, select
Report Non-zero from the Cross-Reader Reporting drop-down box.
1. Configure the IR network by determining where the Reader sits in the IR network.
Example: Reader 1 in Figure 5-13 has a Reader on its right (Reader 2) but no Reader on the left. Reader
2 in Figure 5-13 has a Reader on its right (Reader 3) and a Reader on its left (Reader 1). Reader 3 in
Figure 5-13 does not have a Reader on its right but has one on its left (Reader 2).
Figure 5-13: Three readers covering one direction of wide lane ORT traffic
Note: The Reader IP address applies to the whole Reader and not individual Ethernet ports. You can
view the Reader IP address in the General tab of the Configuration page.
2. If there is a Reader on the left, select the Enable Left Reader check box.
3. Enter the Reader IP address of the left Reader.
lane 1
Reader 1
(left Reader)
A1
RF1
A2
RF2
A3
RF3
A4
RF4
A5
RF5
lane 2 lane 3
Reader 2
(center Reader)
A6
RF6
A7
RF7
A8
RF8
A9
RF9
lane 4 lane 5
Reader 3
(right Reader)
lane 6 lane 8lane 7
RF10
A10
RF11
A11
RF12
A12
RF13
A13
RF14
A14
RF15
A15