Operations and Maintenance Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNon-multilateration LMS transmitter and receiver

161

162

163

164

165

166

167

168

169

170

JANUS

Multi-Protocol Reader Ver. 2: Maintenance Instructions

Confidential UM 360463-202: A12 (Draft) Page 163 of 291

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: MPR2_OPERATIONS_AND_MAINTENANCE-MANUAL_REV A12.DOCX 05/08/2014 11:24

Kapsch TrafficCom

3. If the configuration is not already set, then set Superframe Sync Skip to Select Sync to Every

Superframe, set Add 2 Dummy Frames to No, set Type of Reader Syncing to to JANUS or BADGER,

as applicable.

4. Press Enter to accept the selections.

5. If the superframes for all Readers will be equal (4, 5, or 8 frames) go to Synchronization between MPR2

Readers and perform step 1.

6. If the superframes will be configured as shown in Table 5-3, configure the Superframe Sync Skip and

Add 2 Dummy Frames parameters in the General tab on the Configuration page as outlined in Table

5-3 on page 164.