User's Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNON-MULTIILATERATION LMS TRANSMITTER AND RECEIVER

221

222

223

224

225

226

227

228

229

230

JANUS

Multi-Protocol Reader Ver. 2: Maintenance Instructions

Confidential UM 360450-210: A7 Page 222 of 282

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: UM 360450-210 OPERATIONS AND MAINTENANCE MANUAL.DOCX 10/31/2013 7:56

Kapsch TrafficCom

Replacing a PSM fuse

WARNING:

INSTALLING A FUSE OF THE WRONG TYPE OR RATING MAY CAUSE

A FIRE. INSTALL A TIME LAG FUSE RATED FOR 10A.

1. Set the PSM power switch to the off position.

2. Disconnect the AC power cord.

3. Using a flat-tipped screwdriver, rotate the fuse holder counter-clockwise 180 degrees. Slide out the fuse

holder as shown in Figure 7-1.

Figure 7-1: PSM fuse and fuse holder

4. Rotate the fuse holder clockwise to allow the old fuse to fall free of the fuse holder.

5. Place the new fuse in the fuse holder then slide the fuse holder into the PSM.

6. Using a flat-tipped screwdriver, rotate the fuse holder 180 degrees to secure the fuse holder in the PSM.

Rebooting the CTM

This procedure outlines two ways of rebooting the CTM; using the ON/OFF switch on the CTM, and

using the Reboot button from the CTM web interface.

PSM

fuse holder

fuse