User's Manual

ManualsBrandsKAPSCH TRAFFICCOM CANADA ManualsElectronicsNON-MULTIILATERATION LMS TRANSMITTER AND RECEIVER

161

162

163

164

165

166

167

168

169

170

JANUS

Multi-Protocol Reader Ver. 2: Maintenance Instructions

Confidential UM 360450-210: A7 Page 162 of 282

These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict

confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or

used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.

FILE: UM 360450-210 OPERATIONS AND MAINTENANCE MANUAL.DOCX 10/31/2013 7:56

Kapsch TrafficCom

7. Ensure all the COM Ports selected in step 5 are enabled by selecting the corresponding Serial Port State

check box.

Example: The following screen is shown for reference.

8. Select the Baud Rate, Data Bits, Parity, and Stop Bits to match the LC communication settings.

9. Press Enter to accept the configuration.

Refer to the Configuring the Reader to switch automatically over when an LC link is down procedure on page 225

to configure the Reader to switch over when the connection from the LPM to the LC is down.

IP addresses

Each ethernet port in an IR or LC network must have a unique IP address. The IP addresses should be

set as required for the site network topology. Default IP addresses are:

 Primary and secondary Ethernet 1 port: 192.168.1.50

 Primary side Ethernet 2 port: 192.168.0.50

 Secondary side Ethernet 2 port: 192.168.0.51

Setting the IP addresses

Prerequisites: Connect the service laptop to the Reader configuration port to access the CTM web

interface. Refer to Connecting a service laptop to the Reader, page 40.

Note: A secure record of the IP addresses should be maintained to aid network troubleshooting. The primary

and secondary Ethernet 1 IP addresses will be required if requesting remote assistance from Kapsch Service.

1. Select the Configuration link on the left side panel.

Result: The following screen appears.