User's Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Maintenance Instructions
Confidential UM 360450-210: A7 Page 156 of 282
© Kapsch TrafficCom Canada Inc. 2013
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict
confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or
used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: UM 360450-210 OPERATIONS AND MAINTENANCE MANUAL.DOCX 10/31/2013 7:56
Kapsch TrafficCom
3. If the configuration is not already set, then set Superframe Sync Skip to Select Sync to Every Superframe,
set Add 2 Dummy Frames to No, set Type of Reader Syncing to to JANUS or BADGER, as applicable.
4. Press Enter to accept the selections.
5. If the superframes for all Readers will be equal (4, 5, or 8 frames) go to Synchronization between MPR2
Readers and perform step 1.
6. If the superframes will be configured as shown in Table 0-3, configure the Superframe Sync Skip and Add 2
Dummy Frames parameters in the General tab on the Configuration page as outlined in Table 0-3 on page
157.