User's Manual

_
JANUS
®
Multi-Protocol Reader Ver. 2: Maintenance Instructions
Confidential UM 360450-210: A7 Page 154 of 282
© Kapsch TrafficCom Canada Inc. 2013
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict
confidence and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or
used as the basis for manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: UM 360450-210 OPERATIONS AND MAINTENANCE MANUAL.DOCX 10/31/2013 7:56
Kapsch TrafficCom
3. Select Sync to Every Superframe in the Superframe Sync Skip row.
4. Select No in the Add 2 Dummy Frames row.
5. Select JANUS from the drop-down box in the Type of Reader Synching To row.
6. Repeat these steps for all Readers in the Synchronization circuit.
7. When you are finished, press Enter to accept selections.
Synchronization between JANUS® Readers and BADGER Readers
JANUS
®
and BADGER Readers in the same synchronization network can be configured as in step 1 in the
procedure Synchronization between MPR2 Readers. However, JANUS
®
and BADGER Readers can also have the
superframe configurations shown in Table 0-3 on page 157.
Configuring Synchronization
Prerequisites: Connect the service laptop to the Reader configuration port to access the CTM web
interface. Refer to Connecting a service laptop to the Reader, page 40.
Note: Reader synchronization can also be enabled remotely by the LC if Remote LC Configuration is
enabled.
1. Select the Configuration link on the left side panel.