User's Manual

roofline
� in. preferred,
2 in. maximum
� in. minimum
rear view mirror post
transponder
Preferred Mounting Location - Front View
orientation
arrow
rear view
mirror post
� in. min., 1� in. max
orientation arrow
� in. preferred,
2 in. maximum
roofline
Alternate Mounting Location - Front View
3M
™
Dual Lock
™
strips
HOTPass
®
Transponder - Rear View
2. If there is insufficient space in the preferred location, select an
alternate mounting location beside the rear view mirror post:
3. Two 3M
™
Dual Lock
™
on the back of the HOTPass
®
transponder are used
to mount the transponder to the windshield. Prepare the mounting
location in accordance with 3M
™
document 70-0709-4029-4.
4. Remove the protective backing from the two Dual Lock fasteners.
5. Firmly press the HOTPass
®
transponder against the windshield in the
mounting location, ensuring the orientation arrows are pointing skyward.
Maintain pressure for 15 seconds to ensure a good bond.
6. Remove the transponder by lifting any corner with sufficient force to
separate the Dual Lock
™
strips. Do not reuse the Dual Lock
™
strips after
removing them from the windshield. Obtain new strips as required.
©Kapsch TrafficCom IVHS. All rights reserved. Subject to alteration without notice.
801850-022 Rev A1
Kapsch TracCom IVHS | 6020 Ambler Drive | Mississauga, Ontario L4W 2P1 | CANADA | Phone [phone] | Fax [phone]
54 S. Commerce Way, Suite 100 | Bethlehem, PA 18017 | Phone [phone] | Fax [phone]
E-Mail [e-mail] | [e-mail] | www.kapsch.net
Kapsch Group
The Kapsch Group and its entities Kapsch TracCom, Kapsch CarrierCom and Kapsch BusinessCom are specialised in the future-oriented market
segments of Intelligent Transportation Systems (ITS) and Information and Communication Technology (ICT). Kapsch. Always one step ahead.