User's Manual

Table Of Contents
Portable RSE
DOC#: UM 360453-700 REVISION: C Page 59 of 65
© Kapsch TrafficCom Canada Inc. 2013
These drawings and specifications contain confidential and proprietary information and are the property of Kapsch TrafficCom Canada Inc. and are issued in strict confidence
and will be kept confidential and used solely for the purpose intended and for no other purpose and shall not be transmitted, reproduced, copied, and/or used as the basis for
manufacture or sale of apparatus unless otherwise agreed to in writing by Kapsch TrafficCom Canada Inc.
FILE: P-RSE USER MANUAL - UM360453-700 REV_C.DOCX 08/19/2016 1:44
Kapsch TrafficCom
Replacing the battery pack
Do not store or leave the device or battery pack near a heat source, or otherwise expose it to temperatures in excess
of 140
o
F (60
o
C).
Use only Battery Packs approved for this device.
Do not try to open the battery pack
Do not short the external contacts on the battery pack
Do not install the battery pack backwards so that polarity is reversed.
Do not solder directly onto the battery pack.
Do not place the battery pack in direct sunlight.
In the rare event that the battery pack leaks and fluid get into the eye, do not rub the eye, rinse well with water and
immediately seek medical care.
Determining the software and firmware versions
To determine the Portable RSE software version and RSE main unit firmware version currently running on the Portable
RSE:
1. From any screen (except the Config or Diagnostics screen), tap Menu in the bottom-right corner, then, tap About.
2. The About screen appears, displaying the current software and firmware versions.