User's Manual

T600 Tag Tester User Guide

A316000-852 Jan 19, 2009 Page 9 of 19

EXCEPT AS MAY BE OTHERWISE PROVIDED BY CONTRACT, THESE DRAWINGS AND SPECIFICATIONS CONTAIN

PROPRIETARY INFORMATION AND ARE THE PROPERTY OF MARK IV INDUSTRIES LTD. AND ARE ISSUED IN STRICT

CONFIDENCE AND SHALL NOT BE TRANSMITTED OR REPRODUCED OR COPIED OR USED AS THE BASIS FOR MANUFACTURE

OR SALE OF APPARATUS WITHOUT WRITTEN PERMISSION.

4. Software Installation

Note the PC requirements listed in the “Pre-Installation Check” section.

4.1 Installing the PC Software

You should have received installation media with the T600 PC software.

Create a directory called “T600 tag tester” on your hard drive, and copy the

contents of the installation media into this directory.

4.2 Installing the Calibration Files

You should have received a “calibration floppy” or “calibration CD” for each T600

Tag Tester. This floppy or CD contains important calibration data specific to an

individual tag tester.

Copy the contents of the calibration floppy or CD (*.CAL files) into the

directory in which you installed the T600 PC software.

Note that it is possible to have calibration files for multiple tag testers in the same

directory at the same time. The T600 Tag Tester software will use the one that

matches the serial number as specified in the configuration dialog.

Note: Only a MARK IV technician can calibrate the T600.